About Kivorla
This is Kivorla
The engineering is ours. So is the line it is built on.
Most brands in this category write a brief and choose from a catalogue. The device arrives finished; the logo goes on last.
We begin earlier than that — at the wavelength, the chip, the mould — and we finish later, on a line we own and run ourselves. Eleven years of that work stands behind every Kivorla device.
It is slower than buying a finished device. It is the only way to know, exactly, what we are selling you.
We build what we sell
Nothing here is bought finished and re-badged. Design, tooling and assembly sit under one roof, which is why the answer to a question about any part of a Kivorla device is always in the building.
In-house engineering
Wavelength selection, driver electronics, thermal design and firmware are our engineers' work, not a supplier's default.
Our own production lines
The boards are populated, the devices assembled and the units inspected on lines we own and staff ourselves.
Our own moulds
We own the tooling, so a silicone body can be changed because it fits better — not because a catalogue offers a different shape.
Decisions we were free to make
Owning the line means the harder option stays on the table. Each of our three devices exists because of one.
4-Wavelength Laser Mask
Moulded as one piece rather than assembled from flat panels, so it flexes to a face instead of sitting over it.
3-in-1 Face & Neck LED Mask
Face and neck run from one controller, because treating the face and stopping at the jaw never made sense to us.
9-Spectrum Red Light Panel
Nine wavelengths, each set on its own, because a single fixed output is easier to build and worse to use.
Held to a medical standard
Our quality system is certified to ISO 13485 — the standard written for medical device manufacturers. Nothing obliges a beauty brand to work that way. We are held to it by choice, because a device worn against the skin should answer to something stricter than consumer electronics.
Precise, not persuasive
You will not find claims here about what light will do for your face. You will find the wavelengths, the irradiance, the session length and the materials — stated exactly, on every product page. If a number matters, we print it. If we cannot stand behind a claim, we leave it out.